|
|
|
|
| 1) Tools needed:
Glass cleaner, razor blade or scissors, squeegee, tape measure,
needle, masking tape and a friend to help. |
2) Clean entire
surface of vehicle thoroughly make sure it's free from oil and wax.
Place the decal in the glass and start measuring to center and to
even the decal out, use the masking tape to hold in place. When
your satisfied with the position place a long vertical masking tape
on the center of the decal. Make sure this is attached good. |
3) Remove
the the small tape holding the decal on, Not the long vertical
on the center. Slowly peal the transfer tape from the wax paper,
when you get to the center tape stop and just fold it over. Be care
full not to stick the transfer tape to anything. Cut the wax paper. |
|
|
|
|
| 4)
Hold the clear transfer paper up and from the center place the squeegee
on the vertical tape and squeegee out while holding the clear transfer
tape up from the glass until the squeegee passes on it. |
5)
Keep working the squeegee out from the center out till you have
squeegee all of the decal on. |
6)
Remove the center masking tape and other tape holding the decal
in place. |
|
|
|
|
|
7)
Peal the transfer tape from the wax paper, While holding the tarsier
tape up place the squeegee on the center and squeegee your way
out to the side.
|
8) Keep working
the squeegee out from the center till you have squeegee all of the
decal on. |
9) After you
squeegee all of the surface of the decal slowly peal the clear transfer
tape off. Slowly ass you lift up look if the decal is lifting or
staying on the glass. If their are bubbles just try to work them
out with you fingers or poke it with a needle and press and work
the air out. |
