|
|
|
|
| 1) Tools needed:
Spray bottle, razor blade or scissors, squeegee, blow dryer or heat
gun, tape measure, masking tape and a friend to help, Clean entire
surface of vehicle thoroughly. Mix a gallon or so of water with
a few drops of dishwashing liquid works fine. |
2) . Tape the
graphic to vehicle to give you an idea of where it's going to go.
Use the masking tape to hold in place. |
3) When your
satisfied on the position of the graphic apply two vertical masking
tape on the center of the graphic to create a center hinge. Make
sure the center vertical tape is on good this is very important. |
|
|
|
|
| 4)
Thoroughly wet the entire area of vehicle that is going to receive
graphic with water solution. TRY NOT TO GET THE WAX PAPER WET. |
5)
Separate the transfer w/ the graphic from the waxed paper and spray
the sticky side of the graphic just in case it accidentally sticks
to the vehicle or to its self. |
6)
Cut away the waxed backing paper. |
|
|
|
|
|
7)
Starting from the center apply the graphic to the vehicle. Initially
use light strokes with the squeezing the graphic in to position. The
transfer tape will protect the Decal during this process.
|
8) Starting
at the center re-squeegee using firm strokes. Firm strokes and a
stiff squeegee will force the fluid from underneath the graphic.
Take your time, because if not enough solution is removed from under
the Decal, it will not adhere to the surface enough to allow the
easy removal of the transfer tape. |
9) Transfer
the center vertical tape to the side that you've just done. |
|
|
|
|
| 10)
Make sure the center vertical tape is nice and secured. |
11)
Remove the waxed paper from the other side and spray it with the
solution |
12)
Just repeat the process to the other side. |
|
|
|
|
|
|
Large
Side Graphic Installation
